Ready to Use Acrylic Adhesive for Floorings
NEOFIL M10 is a water based, solvent free acrylic emulsion adhesive, which is designed to give a high initial tack and strong bond strength. It is protected against bio-degradation and is specially designed for use as an adhesive for most kinds of floor coverings.
NEOFIL M10 formulated with blend of high strength polymers, mineral fillers and special additives giving high tensile and shear strength as well as dimensional and ageing stability that achieve the requirements for adhering any type of coarse uneven backed carpeting.
Packaging:
NEOFIL M10 is supplied in 20kg container.
Coverage:
Approximately 3 - 4m2 per kg depending on the condition and absorbency of substrate.
Storage:
NEOFIL M10 should be kept in a cool, dry and covered place.
Shelf life:
12 months from date of production if stored as recommended.
|
|||||||||||||||||||||||
Surface preparation
The surface must be structurally sound, clean and dry and free from shutter release and curing agents, laitance and surface contamination such as dust, dirt, waxes, oils, old adhesives, paint, grease, sealants, weak cement screeds and renders, etc.
Bituminous compounds must be removed completely. New concrete or screeds must be at least 28 days old. New renders or brickwork must be at least 14 days old.
Any repairs, leveling or smoothing should be carried out using suitable product from COLMEF range of repairing and flooring products. Allow the repairing layer to dry prior to application of NEOFIL M10.
Priming
High porous cement surfaces, hardboards, chipboards and plywood must be primed with diluted PRIMER A18 (1 part Primer: 2 parts Water), which must be left to be tack free before applying the adhesive.
Mixing
Stir the pocket contents well before use.
Application
NEOFIL M10 should be applied using a serrated trowel to ensure optimum transfer of adhesive, as follows:
Allow the adhesive to flash off and become slightly tacky before applying the floor covering. Press the floor covering into place and roll all flooring (except cushion flooring) with a 68kg flooring roller or use a smoothing tool as appropriate, from end to end to ensure full contact with the adhesive.
Cleaning
Clean used tools with warm water after application is completed and before product dries.
Recommendations
During application, wear appropriate protective clothing, goggles, gloves and respiratory equipment if necessary.
In case of contact with skin, rinse with water and again wash thoroughly with soap and water. In case of contact with eyes, rinse with plenty of water and seek medical advice accordingly.
If ingested, obtain medical attention immediately. Do not induce vomiting.
The information in this Technical Data Sheet is based on Colmef Monneli’s experience. Colmef Monneli does not accept any liability arising from the use of its products as it has no direct or continuous control over where or how its products are applied. All Colmef Monneli’s Data Sheets are updates on regular basis. It is the user’s responsibility to obtain the latest version.
Ready-Mixed Elastic Tile Adhesive Paste
Acrylic Sealant