Primer for Polyurea
UREAPRIME EP1 is a solvent-free, low viscosity penetrating epoxy primer or coating that may be applied to dry or partially damp surfaces. Designed to seal concrete and reduce off-gassing when concrete temperature is above 20°C.
Consumption:
Apply to the concrete substrate until the surface is saturated. Theoretical coverage is 10 m2/liter at 100 micron wet film thickness (WFT). Actual surface coverage will depend on substrate porosity and roughness. Good painting practices suggest application of two coats for quality assurance. This material is designed to penetrate and will be rapidly absorbed into the concrete making WFT measurement inaccurate.
Packaging:
4 Liter Kits and 20 Liter Kits are available.
Storage:
UREAPRIME EP1 should be stored in original, unopened containers, under normal storage conditions of +15° C to 35° C. In these conditions, product shelf life is 12 months from the date of production.
|
|||||||||||||||||||
Surface Preparation
All surfaces should be sound, clean, dry and free from loose and flaking material, efflorescence, laitance, curing compounds, dirt, oil and grease.
Mixing
Individually mix both Part A and Part B containers prior to measuring out 1 part of Part A to 2 parts of Part B by volume into a clean disposable pail. Completely mix combined A & B for a minimum of one minute before transferring contents to a clean pail. Continue mixing at least another minute, scraping the sides and bottom, to obtain a thorough mix before application.
Application
Apply with small nap chemical resistant rollers or airless spray system with a 0.019 to 0.025 tip size. Do not allow mixed material to remain in spray equipment. It is good working practice to flush equipment between mixed units. For best results, apply this product to concrete when its temperature is stable or falling.
Cleaning
Clean immediately after use using Solvente 10. To clean skin, wash immediately and thoroughly with soap and water. Refer to the Material Safety Data Sheet for additional information on health and safety.
Recommendations
All body parts should be covered and activated charcoal respirators or forced-air breathing apparatus are necessary for safe application of this product. Always keep uncured product away from children. All personnel should read and understand the safety recommendations stated in the Material Safety Data Sheet.
The information in this Technical Data Sheet is based on Colmef Monneli’s experience. Colmef Monneli does not accept any liability arising from the use of its products as it has no direct or continuous control over where or how its products are applied. All Colmef Monneli’s Data Sheets are updates on regular basis. It is the user’s responsibility to obtain the latest version.
Aromatic Pure Polyurea
Brush Grade Polyurea
HYBRID POLYUREA
Two Component Polysulphide Sealant