High Performance Elastic Polyurethane Adhesive
PUCOL is a high performance two-component solvent free tile adhesive. It is a blend of high quality polyurethane resin and hardener with fine fillers that produces a strong thick adhesive that excellently adheres to a wide variety of substrate.
Packaging:
PUCOL is supplied in 5kg kits.
Storage:
PUCOL should be stored in original, unopened containers, under normal storage conditions of 10°C to 30°C. Avoid product freezing. In these conditions, product shelf life is 12 months from the date of production. Keep it far away from direct sunlight and fire source.
|
|||||||||||||||||||||||||
The surface of the substrate shall be sound, clean and uncontaminated. This preparation shall be such as to leave a sound exposed surface free from dust, loose particles and any deleterious matter. If the surface is defective or has laitance, it must be cut back to a sound base.
New concrete or cementitious surfaces should be at least 28 days old and have moisture content not exceeding 5%. Old or existing surface should be refurbished mechanically to ensure clear and sound substrate.
Mixing
Mix Component A and Component B thoroughly using a heavy duty slow speed drill paddle for 2-3 minutes until a homogenous mix is achieved.
Application
Place the tile onto the adhesive bed. Apply the product onto the support with a toothed spatula, spreading it at first with the straight edge of the spatula, and immediately after with the toothed one.
Apply sufficient pressure on the tile/board during fixing it with slight twisting movement in order to ensure good contact with the adhesive.
If a tight waterproofing is required to the substrate, spread PUCOL on the sub base with the smooth spatula and leave a thickness of at least 2 mm.
After about 24 hours, apply the second coat of product for the tile fixing. In case of large size tiles, it is necessary to spread the adhesive also to the backside of the tile and then place the tiles into the adhesive bed.
Finishing
Remove excess adhesive with solvent before the material has set. Joint grouting between tiles may be commenced 12 hours after tiles have been laid. Final hardening is about 7 days.
Cleaning
Clean tools and equipment with Solvente 10 immediately after use. Remove the hardened material using mechanical means.
Recommendations
Handle the product with caution. Using gloves and goggles, avoid any contact with eyes and skin. In case of contact with eyes, wash abundantly with warm water and consult a doctor immediately. For further and complete information about the safe use of our product please refer to the latest version of our MSDS.
The information in this Technical Data Sheet is based on Colmef Monneli’s experience. Colmef Monneli does not accept any liability arising from the use of its products as it has no direct or continuous control over where or how its products are applied. All Colmef Monneli’s Data Sheets are updates on regular basis. It is the user’s responsibility to obtain the latest version.
Synthetic Resin Primer