Bitumen Waterproofing

Monneli Betoboard

Protective Bituminous Board

BETOBOARD can be used in the following:
• Protective layer during backfilling for areas below the ground (basements, foundation walls,etc.)
• Used to avoid damagae during construction traffic
• Protects horizontal areas before laying of concrete, etc.
• Protects the waterproofing layer of foundation walls, parking decks, terraces, flower boxes and concrete slabs, etc.
• Protective walkway to avoid damage to waterproofing layer on roofs against foot traffic to inspect air conditioning units, machinery, mineral slate finished version.
• Can be used as support element for refurbishment of the waterproofing in the 6mm version mechanically fixed.
back to Waterproofing
Technical Information
Product Description

BETOBOARD is a pre-formed bituminous board modified with a special rigid compound. It is used to protect the waterproofing during backfilling procedures (retaining walls, fixed pavements, cast concrete etc.) and construction traffic.

  • Very high resistance to puncture
  • Resists and protect against normal site traffic
  • Resists to normal chemicals found in the soil, chlorides, lasts, etc
  • Protects while pouring concrete slab, etc.
  • Water impermeable and resistant to vapor transmission
  • Compatible with most commonly used waterproofing methods
  • Resistant to normal impact during backfilling procedures
  • Not affected by repeated immersion in ground water, rot-proof
  • Can be applied by torching and is suitable for mechanical fixing.
  • Durable
  • Manufactured to suit hot climate conditions
Compiliance Standard
  • ASTM D36
  • EN1426
  • EN12730
  • EN13501-1
Packaging, Coverage / Consumption

BETOBOARD is supplied in sheets

Available in 3mm, 4mm and 6mm.

Dimension :  1m x 2m

Shelf Life & Storage

BETOBOARD must be stored in a well ventilated, covered storage area away from any source of direct heat. Rolls must be kept in an upright position at all times. Shelf life is 12 months from the date of production  if stored properly in original unopened packing.

Technical Properties
Type of Compound


Softening Ring & Ball (ASTM D36)



1.53 kg/L

Penetration at 25°C (EN1246)

13 (1/10mm)

Static Puncture Resistance (EN 12730)


Mass x unit area (EN 1849)

1.8kg/m2 for 3mm

9.3kg/m2 for 6mm

Application Information
Instructions for use


BETOBOARD should be applied  over the waterproofing system on both the flat and vertical areas by spot binding, lightly torching the material or with a suitable adhesive. It can also be glued using bituminous mastic.

Additional Information
Health & Safety

BETOBOARD  have no health hazards when used with our standard application recommendations.

additional materials
Fast Download
Technical Properties Sheet
download (*.pdf 0.08Mb)
More Products from this section
Monneli Asfabit

Cold Applied Bitumen Emulsion

Monneli Asfabit RB

Flexible, Rubberized Bitumen Emulsion

Monneli Asfabit RB+


Monneli Asfabit RBL


Monneli Asfabit RBL +

Rubberized Bitumen Emulsion

view more
Monneli Betofer

Corrosion-Proof Cement Slurry for Steel Reinforcement

It is used as a protection for steel reinforcement against corrosion when concrete repair is needed.
BETOFER can also be employed as an adhesive primer for the repairing mortars or for new concrete castings onto the old one.
Contact us
Choose a location
P.O. Box: 123808, Dubai
Toll: +971 4 8803488
Fax: +971 4 8803450
Site Map