Spray Polyurethane Foam
COLMEFOAM HD is 141B-based polyol suitable for polyurethane spray foam systems used for the insulation of roofs, sheds, and rays. This system is classified as B3 according to DIN 4102 standards. The R141B blowing agent is already mixed with the polyol.
Packaging:
Storage:
Store in original, unopened, sealed and undamaged packaging in dry conditions at temperatures between +15°C and +25°C. Protect from direct sunlight, heat and moisture. In these conditions its stability is of at least 6 months.
|
|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
Surface Preparation
The surface of the concrete shall be sound, clean and uncontaminated. This preparation shall be such as to leave a sound exposed concrete surface free from dust, loose particles and any deleterious matter.
Application
COLMEFOAM HD should be applied with a multi-component spray system. Upon contact with the surface, the mixture instantly adheres and expands into a rigid foam.
Recommendations
During application, wear appropriate protective clothing, goggles, gloves and respiratory equipment if necessary.
In case of contact with skin, rinse with water and again wash thoroughly with soap and water. In case of contact with eyes, rinse with plenty of water and seek medical advice accordingly.
If ingested, obtain medical attention immediately. Do not induce vomiting.
Refer to MSDS for more detailed safety instructions.
The information in this Technical Data Sheet is based on Colmef Monneli’s experience. Colmef Monneli does not accept any liability arising from the use of its products as it has no direct or continuous control over where or how its products are applied. All Colmef Monneli’s Data Sheets are updated on regular basis. It is the user’s responsibility to obtain the latest version.
Non-Woven Geotextile Reinforcing / Protection Fabrics
Spray Polyurethane Foam
FLEXIBLE HIGH PERFORMANCE FLUID URETHANE EPOXY GROUT